/* 
Soil Mosture Sensor
A0 - Soil Mosture Sensor
D2:D6 - LEDS 1,2,3,4,5
LED1 - Green
LED2 - Green
LED3 - Green
LED4 - YELLOW
LED5 - RED
Connect the Soil Mosture Sensor to anolog input pin 0, 
and your 5 led to digital out 2-6
*/
int led1 = 2;
int led2 = 3;
int led3 = 4;
int led4 = 5;
int led5 = 6;
int mostureSensor = 0;
void setup() {
  // Serial Begin so we can see the data from the mosture sensor in our serial input window. 
  Serial.begin(9600);
  // setting the led pins to outputs
  pinMode(led1, OUTPUT);
  pinMode(led2, OUTPUT);
  pinMode(led3, OUTPUT);
  pinMode(led4, OUTPUT);
  pinMode(led5, OUTPUT);
}
// the loop routine runs over and over again forever:
void loop() {
  // read the input on analog pin 0:
  int sensorValue = analogRead(mostureSensor);
  // print out the value you read:

  Serial.println(sensorValue);
 if (sensorValue >= 820)
 {
 digitalWrite(led1, HIGH);
 digitalWrite(led2, HIGH);
 digitalWrite(led3, HIGH);
 digitalWrite(led4, HIGH);
 digitalWrite(led5, LOW);
}
else if (sensorValue >= 615  && sensorValue < 820)
 {
 digitalWrite(led1, HIGH);
 digitalWrite(led2, HIGH);
 digitalWrite(led3, HIGH);
 digitalWrite(led4, LOW);
 digitalWrite(led5, LOW);
}  
else if (sensorValue >= 410 && sensorValue < 615)
 {
 digitalWrite(led1, HIGH);
 digitalWrite(led2, HIGH);
 digitalWrite(led3, LOW);
 digitalWrite(led4, LOW);
 digitalWrite(led5, LOW);
}    
else if (sensorValue >= 250 && sensorValue < 410)
 {
 digitalWrite(led1, HIGH);
 digitalWrite(led2, LOW);
 digitalWrite(led3, LOW);
 digitalWrite(led4, LOW);
 digitalWrite(led5, LOW);
}
else if (sensorValue >= 0 && sensorValue < 250)
 {
 digitalWrite(led1, LOW);
 digitalWrite(led2, LOW);
 digitalWrite(led3, LOW);
 digitalWrite(led4, LOW);
 digitalWrite(led5, LOW);
}
  delay(1000);        // delay 1 second between reads
}